EDUCATION / ARTICLE
Secondary E-Maths Vectors: Turn a Line Ratio Into a Directed Arrow
TestPapersFree · 2026-11-21 08:06:02
In a Singapore E-Maths and A-Maths discussion, a student asked how to approach vector questions after getting one wrong in a practice paper. A reply suggested joining arrows in order and using the endpoint to check the result. That advice is especially helpful when a single diagram contains both a direction and a ratio. SGExams vector question and replies
Read the vector name as two instructions
For vector OP, start at O and finish at P. Draw a tiny arrow for each segment of the route you plan to take. If you know vector OA and vector AP, then OA + AP gives OP because the first step ends where the second begins. If the diagram gives AB but your route takes you from B to A, write BA = −AB. The minus sign reverses the arrow while preserving its length.
A useful first line in your working is the route in named vectors, with no substitutions yet. This lets you inspect the start, the intermediate point and the destination. The route also gives you a way to recover your place if a later line of algebra starts to look unfamiliar. SEAB’s 2027 SEC G3 Mathematics syllabus includes directed line segments and using sums and differences to express vectors. SEAB K310 Mathematics syllabus, section G7
Build the fraction from the whole segment
Suppose OA = a and AB = b. P lies between A and B, with AP : PB = 2 : 1. Sketch A, P and B in that order and mark two equal parts between A and P and another part between P and B. The whole AB has three parts. Since AP points in the same direction as AB, AP = ⅔b. The route through A gives OP = a + ⅔b.
Check the result by going through B. Vector OB is a + b. From B to P you travel one of the three parts backwards, giving BP = −⅓b. Adding those steps again gives a + ⅔b. This check catches two common slips. The ratio 2 : 1 compares two pieces of AB, so the denominator for a fraction of AB is 3. The last step from B is towards A, so its coefficient is negative.
Use a short route for nearby points
Place Q on the same segment so that AQ : QB = 1 : 2. What is PQ in terms of b? Both points lie on AB, and Q is one part from A while P is two parts from A. Starting at P, move one part towards A to reach Q. Thus PQ = −⅓b. You can also subtract the position vectors to obtain OQ − OP = (a + ⅓b) − (a + ⅔b). The a terms cancel because the shared start at O contributes equally to both position vectors.
Practise with a path that leaves the line
On the same sketch, add C so that OC = b. Find PC by going back to O and then out to C. You get −a − ⅔b + b = −a + ⅓b. Read that expression as instructions from P. Moving by −a leaves you two thirds of the way along a copy of b from O. The remaining third brings you to C.
For paper practice, find a vector question and write the directed route beside the diagram before starting the algebra. After checking the answer, label any mistake as a route error, a fraction error or a direction error. Redo the line where it began. Secondary E-Maths test papers
Add Comment
This policy contains information about your privacy. By posting, you are declaring that you understand this policy:
This policy is subject to change at any time and without notice.
These terms and conditions contain rules about posting comments. By submitting a comment, you agree with these rules:
Failure to comply with these rules may result in being banned from submitting further comments.
These terms and conditions are subject to change at any time and without notice.
Comments