TestPapersFreeTHE EDUCATION COLLECTION
SINGAPORE EXAMINATION PAPERS
Primary · Secondary · Junior College
Browse schools

THE SCHOOL DIRECTORY

Primary schools 35
Secondary schools 123
Junior College schools 23
Levels, subjects & past years

Primary

Secondary

Junior College

Explore Singapore school collections, subjects and past years.

EDUCATION / ARTICLE

Secondary E-Maths Circle Areas: Choose the Reference Before Rounding

TestPapersFree · 2026-11-18 08:04:17

Two circular signs differ in area by the same number of square centimetres whichever way you compare them. The percentage difference can change because the reference area changes. After the 2026 O-Level E-Maths Paper 2, an r/SGExams participant asked whether rounding an area comparison to two significant figures was appropriate because numbers in the question seemed to use that precision. Here is a way to settle both the denominator and the rounding in a fresh example. 2026 O-Level Mathematics discussion

Write the reference area in words

Suppose a school is replacing a large circular display panel with a smaller one. The original panel has a radius of 13 cm and the smaller panel has a radius of 11 cm. The question asks by what percentage the area decreases. Write “difference divided by original area” before entering numbers. The original panel is the starting point in the comparison, so its area represents 100%.

The two exact areas are 169π cm² and 121π cm². Their difference is 48π cm². The percentage decrease is therefore (48π ÷ 169π) × 100%, or (48 ÷ 169) × 100%. This gives approximately 28.402%, which is 28.4% to three significant figures. Keeping π in both areas makes the cancellation visible and avoids introducing small rounding errors by calculating two separate decimals.

Reverse the comparison and see what changes

Now imagine starting with the smaller panel and replacing it with the larger one. The increase is still 48π cm², but the area you started with is now 121π cm². The percentage increase is (48 ÷ 121) × 100% ≈ 39.7% to three significant figures. Both percentages describe the same pair of areas. The smaller reference in the second calculation makes the difference a larger share of the starting area.

Look for wording that identifies the reference. “How much smaller is B than A, as a percentage of A?” names A directly. “What percentage of B is covered by the difference?” names B. If there is a design rule such as “reduce the original area by at least 30%”, underline “original” and compare the unrounded value with the threshold. In our example, about 28.402% falls short of 30%. If the question supplies a specific definition of percentage difference, use the reference stated in that definition.

Read the accuracy instruction for this answer

SEAB’s 2027 G3 Mathematics syllabus says to give non-exact numerical answers to three significant figures, or angles in degrees to one decimal place, unless the question specifies a different accuracy. Look for an instruction attached to the part you are answering or one that expressly applies to the whole question. The number of digits in a figure supplied as data does not by itself give an instruction for your final answer. In the panel example, the same calculator value becomes 28% if the question specifically asks for two significant figures. SEAB 2027 G3 Mathematics syllabus

Check whether the question changed a length or an area

Try a separate practice prompt. A designer increases a circle’s radius by 10%. What is the resulting percentage increase in area? If the old radius is r, the new radius is 1.10r. That multiplies the area by 1.10² = 1.21, an increase of 21%. An area calculation squares the linear scale factor, which explains why copying the radius percentage gives the wrong result. The same factor works if the stated 10% increase applies to the diameter, because the radius then grows by the same proportion.

For practice with school papers, pick an E-Maths mensuration problem with a percentage condition. Write the two areas with their units, circle the area that represents 100%, and retain the exact ratio or calculator precision until the last line. If a solution sheet uses different rounding, check the instructions and compare your values before rounding. TestPapersFree Secondary E-Maths papers

← More articles

Add Comment

* Required information
1000

Comments

No comments yet. Be the first!

ONE COLLECTION. EVERY STAGE.

Find your next practice paper.

PRIMARY

Strong foundations.

Explore Primary school papers →

SECONDARY

The next step.

Explore Secondary school papers →

JUNIOR COLLEGE

A wider horizon.

Explore Junior College school papers →