TestPapersFreeTHE EDUCATION COLLECTION
SINGAPORE EXAMINATION PAPERS
Primary · Secondary · Junior College
Browse schools

THE SCHOOL DIRECTORY

Primary schools 35
Secondary schools 123
Junior College schools 23
Levels, subjects & past years

Primary

Secondary

Junior College

Explore Singapore school collections, subjects and past years.

EDUCATION / ARTICLE

O-Level A-Maths Stationary Points: What to Do When the Second Derivative Is Zero

TestPapersFree · 2026-11-22 08:03:37

In the SGExams discussion after the 2026 O-Level Additional Mathematics Paper 1, students asked whether the second derivative test could be used to classify a stationary point. The answer depends on the value it gives you. SEAB’s 2026 syllabus includes maximum and minimum turning points, stationary points of inflexion, and use of the second derivative test to distinguish maxima and minima. SGExams Paper 1 discussion · SEAB Additional Mathematics syllabus 4049, section C1

Find the point, then classify it

Start by solving f′(x) = 0. This identifies where the tangent is horizontal. Substitute each solution into the original function to obtain the corresponding y-coordinate. Then classify each point separately. At a stationary point, a positive second derivative gives a local minimum and a negative one gives a local maximum. A zero second derivative leaves the classification open, so examine the behaviour on either side.

Compare three curves at the origin

For f(x) = x4, the first derivative is 4x3 and the second is 12x2. Both are zero at the origin. Just to the left of zero, the first derivative is negative because the cube of a negative number is negative. Just to the right, it is positive. The function falls and then rises, so (0, 0) is a local minimum.

For g(x) = −x4, the derivatives are −4x3 and −12x2. The first derivative goes from positive to negative, so the curve rises and then falls. The origin is a local maximum, even though the second derivative is again zero there.

For h(x) = x3, the first derivative is 3x2, which is positive on both sides of zero. The curve continues rising past its horizontal tangent. The second derivative is 6x, which changes from negative to positive, so the curve changes concavity at zero. Together, the horizontal tangent and the change of concavity give a stationary point of inflexion.

Show which interval each sign describes

When you have several stationary values, put them on a number line before testing signs. A test point should lie in the interval immediately next to the stationary value you are classifying. For derivatives you can factor, the signs of the factors can establish what happens throughout each interval. In these three examples, the signs of x2 and x3 give the result directly on either side of zero. State the sign change and finish with the point and its nature. If a question specifies a method, follow that wording.

For revision, look for a stationary-point question in the TestPapersFree Secondary A-Maths collection. Before checking the solution, label your working in three parts on the page: the equation that locates the point, the evidence for its nature and the final coordinates. If one part is missing, add that part while the original working is still in front of you.

← More articles

Add Comment

* Required information
1000

Comments

No comments yet. Be the first!

ONE COLLECTION. EVERY STAGE.

Find your next practice paper.

PRIMARY

Strong foundations.

Explore Primary school papers →

SECONDARY

The next step.

Explore Secondary school papers →

JUNIOR COLLEGE

A wider horizon.

Explore Junior College school papers →